
On this page (7 sections)
Seed, sod, fertilizer, mulch, soil and gravel are all ordered from one number: the area you are covering. Measuring it well takes ten minutes with a tape measure and a sketch, and it is the step that decides whether your order is right.
What you need
- A 100 ft (30 m) tape, or a measuring wheel for big yards.
- A few stakes or skewers to mark corners.
- Paper to sketch the area and write measurements on.
Step 1: split the area into simple shapes
Circle: π × (Diameter ÷ 2)² · Trapezoid: (Side A + Side B) ÷ 2 × Height
Sketch the yard from above and draw lines that divide it into these shapes. Measure heights at right angles — not along a sloping edge.
Step 2: add the pieces and subtract cut-outs
An L-shaped back yard: a 40 × 25 ft main lawn and a 15 × 12 ft side strip, with a 12 × 10 ft patio inside the main lawn.
- Main lawn: 40 × 25 = 1,000 sq ft
- Side strip: 15 × 12 = 180 sq ft
- Patio (subtract): 12 × 10 = 120 sq ft
- Lawn area = 1,000 + 180 − 120 = 1,060 sq ft (98.5 m², 117.8 sq yd)
Step 3: curved and irregular edges
Lay a straight tape along one side as a baseline. Every few feet along it, measure the width at right angles to the curved edge. Each pair of neighbouring widths forms a trapezoid: (width 1 + width 2) ÷ 2 × spacing. Add them up.
A curved bed 20 ft long, widths measured every 5 ft: 12, 14, 15, 13, 10 ft.
- (12 + 14) ÷ 2 × 5 = 65 sq ft
- (14 + 15) ÷ 2 × 5 = 72.5 sq ft
- (15 + 13) ÷ 2 × 5 = 70 sq ft
- (13 + 10) ÷ 2 × 5 = 57.5 sq ft
- Total ≈ 265 sq ft
Closer spacing gives a closer answer. For a whole curved lawn, combine this with rectangles for the straight parts.
Slopes
Measurements taken with a tape laid on the ground follow the slope, which is what you need for sod, seed and fabric that cover the surface. Volumes such as mulch or gravel depth are also spread on the surface, so for gentle slopes the difference is small; on steep banks measure along the slope and add a little extra.
Converting units
- Square yards = square feet ÷ 9
- Acres = square feet ÷ 43,560
- Square metres = square feet × 0.09290304 (exact)
The Square Footage Calculator adds and subtracts any number of shapes in mixed units and converts the total. Use the result in the Grass Seed, Sod, Fertilizer and Mulch calculators.
Sources
- NIST Special Publication 811 — Guide for the Use of the International System of Units (SI) — Exact definitions of the inch, foot, yard, acre, pound, US gallon and the cubic yard used in every calculation in this guide.
Sources were checked when this guide was published. Where published guidance differs, this guide says so; for structural work, follow your local specification.
Worked examples are generated by the same tested calculation engine as our calculators. See our editorial policy and methodology.


