Soil & Garden Beds

How to Calculate Garden Edging for Beds, Borders and Tree Rings

Measure the edges of beds, borders and tree rings and turn them into feet of edging, pieces and stakes — with a tree-ring circumference chart and worked examples.

Raised vegetable beds and a round brick planter in a community garden, with bark mulch covering the ground between them
Raised beds and a round planter with mulch between them. Edging lengths come from the perimeter of each bed. Photo: PermaCultured via Flickr · CC BY 2.0 · cropped and resized
On this page (8 sections)

Edging keeps mulch in, grass out and gives beds a crisp line. Buying the right amount means measuring the edge, not the area — and edges are easy to underestimate on curved beds.

Straight-sided beds

Perimeter = 2 × (Length + Width) for a rectangle; add the sides for other shapes

Leave out any side that runs against a wall, a fence, a path or a patio that already holds the edge.

Round beds and tree rings

Circumference = π × Diameter
DiameterEdging neededMetric
3 ft9.4 ft2.87 m
4 ft12.6 ft3.83 m
5 ft15.7 ft4.79 m
6 ft18.8 ft5.75 m
8 ft25.1 ft7.66 m
10 ft31.4 ft9.58 m

Exact for a true circle, before any allowance for joints.

Curved, free-form beds

Lay a garden hose or a rope along the edge, mark where it starts and ends, then straighten it and measure. This is faster and more accurate than trying to fit geometric shapes to a curve.

Brick, block and paver edging

Unit edging is counted the same way, by length:

Units = Edge length ÷ (Unit length + Joint), rounded up

For a soldier course (bricks standing on end) use the brick’s width as the unit length; for bricks laid lengthwise use the length. A 40 ft border edged lengthwise with 8 in bricks and no joint takes 480 ÷ 8 = 60 bricks; the same border as a soldier course with 4 in faces takes 120. Add a few for cuts at corners and curves.

Choosing edging

  • Flexible rolls follow curves easily and are quick to install with stakes.
  • Rigid sections (metal or composite) give straight, crisp lines and usually join with connectors.
  • Brick, block or stone can double as a mowing strip if laid flush with the lawn.

Whatever you choose, the product’s piece length and joint method decide how the edge length turns into pieces.

From length to pieces and stakes

Pieces = Edge length × (1 + Allowance %) ÷ Piece length, rounded up
Stakes = Pieces × Stakes per piece

Worked examples

A 20 × 5 ft border along a lawn on three sides (the fourth is a fence), 20 ft rolls with 5 stakes each, 5% extra.

  1. Edge = 20 + 5 + 5 = 30 ft (not the full 50 ft perimeter)
  2. With 5%: 31.5 ft → 2 rolls, 10 stakes

A 6 ft tree ring with 4 ft edging sections.

  1. π × 6 = 18.85 ft; with 5% = 19.79 ft
  2. Pieces = 5

Then fill the bed: the Mulch Calculator handles rings and borders, and the Landscape Edging Calculator does the edge arithmetic for you.

Sources

  1. NIST Special Publication 811 — Guide for the Use of the International System of Units (SI) — Exact definitions of the inch, foot, yard, acre, pound, US gallon and the cubic yard used in every calculation in this guide.

Sources were checked when this guide was published. Where published guidance differs, this guide says so; for structural work, follow your local specification.

Worked examples are generated by the same tested calculation engine as our calculators. See our editorial policy and methodology.