Measurements & Calculations

9 Common Landscaping Material Ordering Mistakes (and How to Fix Them)

Inches vs feet, tons vs tonnes, bags by weight, compaction and double-counted waste: nine mistakes when ordering gravel, soil and mulch, and the fixes.

A finished yard with stone paving, boulders, gravel and drought-tolerant planting
A finished yard of stone, gravel and planting. Most ordering mistakes on projects like this come from units, not from measuring. Photo: Jeremy Levine Design via Flickr · CC BY 2.0 · cropped and resized
On this page (11 sections)

Running short in the middle of a job — or paying for a pile you cannot use — usually comes down to a handful of avoidable mistakes. Here they are, with the fix for each.

1. Multiplying inches by feet

20 ft × 10 ft × 3 in is not 600 cubic feet. Convert the depth first: 3 in = 0.25 ft, so the volume is 50 cu ft = 1.85 cu yd. Fix: divide inches by 12 — or let a calculator handle the units.

2. Confusing cubic feet and cubic yards

One cubic yard is 27 cubic feet, not 3 or 9. Fix: cubic feet ÷ 27 = cubic yards.

3. Mixing up tons and tonnes

A US ton is 2,000 lb; a metric tonne is 1,000 kg (about 2,205 lb) — roughly 10% more. Fix: ask which one a quote means; see the Cubic Yards to Tons Calculator.

4. Assuming every material weighs the same

A cubic yard of gravel weighs several times as much as a cubic yard of mulch. Fix: convert volume to weight with the density of that material — ideally the supplier’s figure.

5. Counting bags by weight as if they were by volume

A 50 lb bag of gravel and a 50 lb bag of compost hold very different volumes. Fix: use the volume or coverage on the label, or convert with the density.

6. Forgetting compaction

Crushed stone bases and some soils compact into a thinner layer than they were spread. Fix: ask your supplier how much extra to allow for compacted layers.

7. Adding the allowance twice

Adding 10% in the calculator, then rounding up, then “a bit more to be safe” can add a quarter or more. Fix: add the allowance in one place — see how to calculate material waste.

8. Ignoring ordering steps and minimum loads

If a yard sells in fixed steps, 2.1 yards may be charged as 2.5. Fix: ask about steps and minimums, and compare totals — the Bulk vs Bagged Cost Calculator rounds to the step you enter.

9. Measuring the plan, not the ground

Sketches drift from reality. Fix: measure on site, after edging and forms are in place, and recalculate before you order.

Already ordered the wrong amount?

  • Too little: order the shortfall from the same supplier and product so the colour matches; spread what you have evenly rather than fully covering part of the area.
  • Too much: unopened bags can often be returned; extra mulch or soil can top up other beds; spare gravel is useful for repairs and drainage.

Sources

  1. NIST Special Publication 811 — Guide for the Use of the International System of Units (SI) — Exact definitions of the inch, foot, yard, acre, pound, US gallon and the cubic yard used in every calculation in this guide.

Sources were checked when this guide was published. Where published guidance differs, this guide says so; for structural work, follow your local specification.

Worked examples are generated by the same tested calculation engine as our calculators. See our editorial policy and methodology.