
On this page (7 sections)
Segmental retaining wall blocks stack in courses, like bricks without mortar. Counting them is straightforward once you know the face size of one block — and the two places people usually go wrong are the buried course and stepped walls.
This guide covers quantities. Base preparation, setback, drainage and reinforcement are specified by each block manufacturer, and taller walls or walls holding back slopes, drives or buildings need an engineered design.
What to measure
- Wall length along the face. For a curved wall, measure along the front of the curve with a hose or tape.
- Total height including any course that will be buried below finished grade.
- Block face size — the visible length and height of one unit, from the product sheet (not the depth into the wall).
The formula
Courses = Wall height ÷ Block face height, rounded up
Blocks = Blocks per course × Courses, plus an allowance for cuts
Worked example
A 32 ft wall, 24 in high including a buried course, with 12 × 4 in blocks, 12 in caps and 12 in of drainage gravel behind, 5% extra.
- Blocks per course = 384 in ÷ 12 = 32
- Courses = 24 ÷ 4 = 6
- Blocks = 32 × 6 = 192; with 5% = 202
- Caps = 32 × 1.05 → 34
- Drainage gravel = 32 × 2 × 1 = 64 cu ft = 2.37 cu yd
Blocks per square foot of wall face
A quick cross-check is the face area: blocks per square foot = 144 ÷ (face length × face height in inches).
| Block face | Per sq ft | Per 100 sq ft |
|---|---|---|
| 12 × 4 in | 3 | 300 |
| 16 × 6 in | 1.5 | 150 |
| 18 × 6 in | 1.33 | 133 |
| 12 × 6 in | 2 | 200 |
Exact face-area arithmetic. Counting course by course (above) is more accurate for short walls because each course rounds up to whole blocks.
Stepped walls
When the ground rises along the wall, the base steps up and the wall gets lower. Split it into sections of constant height and add them:
A 30 ft wall in three 10 ft steps, 24, 16 and 8 in high, with 12 × 4 in blocks.
- Step 1: 10 × 6 = 60 blocks
- Step 2: 10 × 4 = 40 blocks
- Step 3: 10 × 2 = 20 blocks
- Total = 120 blocks before allowance
The other materials
- Leveling pad / base: trench length × width × depth from the manufacturer’s guide — use the Gravel Calculator.
- Drainage aggregate: length × height × the specified width behind the blocks.
- Caps and adhesive: caps = wall length ÷ cap length; adhesive coverage is on its label.
The Retaining Wall Block Calculator does all of this in one place, in feet or metres.
Sources
- NIST Special Publication 811 — Guide for the Use of the International System of Units (SI) — Exact definitions of the inch, foot, yard, acre, pound, US gallon and the cubic yard used in every calculation in this guide.
Sources were checked when this guide was published. Where published guidance differs, this guide says so; for structural work, follow your local specification.
Worked examples are generated by the same tested calculation engine as our calculators. See our editorial policy and methodology.


