Patios & Pavers

How Much Concrete Do I Need? Slabs, Footings and Post Holes

Work out cubic yards and bags of concrete for a slab, a strip footing or post holes — the formulas, a per-100-sq-ft chart, worked examples and ordering tips.

A wheel loader moving gravel on a large stockpile
Loading bulk aggregate. Concrete, like gravel, is ordered by volume — so the first job is an accurate number of cubic yards. Photo: myARDOT via Flickr · CC BY 2.0 · cropped and resized
On this page (6 sections)

Running out of concrete halfway through a pour is a real problem: the first part starts to set before the rest arrives. Ordering a sensible amount comes down to three measurements and one division.

This guide covers quantities only. Thickness, reinforcement, the base and joints depend on what the concrete carries, the soil and the climate — follow your plans, local code or a qualified professional.

Slabs, pads and paths

Cubic feet = Length (ft) × Width (ft) × Thickness (ft)
Cubic yards = Cubic feet ÷ 27

Thickness is usually given in inches: divide by 12 first (4 in = 0.333 ft). Per 100 square feet of slab:

ThicknessCubic feetCubic yardsCubic metres
3.5 in29.171.080.826
4 in33.331.2350.944
5 in41.671.5431.18
6 in501.8521.416

A 16 × 12 ft patio slab, 4 in thick, with 10% extra.

  1. 16 × 12 × 0.333 = 64 cu ft = 2.37 cu yd
  2. With 10%: 2.61 cu yd (1.99 m³)

Strip footings

A continuous footing is just a long, narrow slab: length × width × depth.

60 ft of footing, 16 in wide and 8 in deep, with 10% extra.

  1. 60 × (16 ÷ 12) × (8 ÷ 12) = 53.3 cu ft
  2. With 10%: 58.7 cu ft = 2.17 cu yd

Post holes and round columns

Cubic feet per hole = π × (Diameter ÷ 2)² × Depth (all in feet)

12 fence-post holes, 8 in across and 30 in deep, with 10% extra.

  1. One hole: π × (4 ÷ 12)² × 2.5 = 0.873 cu ft
  2. × 12 holes = 10.47 cu ft; with 10% = 11.52 cu ft
  3. The post takes up some of the hole, so this is slightly more than you will use.

Bags of premixed concrete

Bags = Volume ÷ Yield per bag, rounded up

Every bag of premixed concrete states its yield — how much concrete it makes once mixed. It depends on the product and bag size, so read it from your bag; the weight alone does not tell you. Divide your total by that figure and round up. For the post holes above, 11.52 cu ft ÷ the label yield gives the number of bags.

Ordering tips

  • Ready-mix or bags: bags suit post holes and small pads; for slabs, ready-mix is usually less work. Suppliers have minimum loads and fixed ordering increments — ask before you round.
  • Allowance: sub-grades are never perfectly flat and forms bow a little. A small allowance is cheaper than running short.
  • Check the forms: measure inside the finished forms, not the plan, before you order.

The Concrete Calculator does all of this — slabs, footings and post holes, any units, and bag counts from your bag’s yield.

Sources

  1. NIST Special Publication 811 — Guide for the Use of the International System of Units (SI) — Exact definitions of the inch, foot, yard, acre, pound, US gallon and the cubic yard used in every calculation in this guide.

Sources were checked when this guide was published. Where published guidance differs, this guide says so; for structural work, follow your local specification.

Worked examples are generated by the same tested calculation engine as our calculators. See our editorial policy and methodology.