Soil & Garden Beds

How Much Topsoil Does a Raised Garden Bed Need?

Calculate the soil for one or several raised beds in cubic feet, cubic yards, liters and bags — with worked imperial and metric examples and tips on settling.

Swiss chard and other vegetables growing in a raised garden bed
Vegetables in a raised bed. Beds are usually filled a little below the rim so soil and mulch stay inside. Photo: normanack via Flickr · CC BY 2.0 · cropped and resized
On this page (7 sections)

Raised beds hold more soil than most people expect. A single 4 × 8 ft bed filled a foot deep needs 32 cubic feet — more than a cubic yard — and the bags add up quickly. Here is how to get the number right before you buy.

The formula

Soil volume = Length × Width × Fill depth × Number of beds

Use the inside dimensions of the bed (the walls take up space), and the depth you will actually fill to — usually an inch or two below the rim so soil and mulch don’t wash over the edge. Then convert:

How much soil a raised bed holdsAn 8 by 4 foot raised bed, 12 inches tall, filled 10 inches deep holds 26.7 cubic feet of soil. Bed 12 in Fill 10 in Leave 1–2 in below the rim Soil volume uses the INSIDE size and the depth you will actually fill 8 × 4 ft bed = 26.7 ft³ = 0.99 yd³ = 755 L
Diagram: measure inside the walls and fill a little below the rim (illustrative, not to scale). Numbers computed by the calculator engine.
  • Cubic feet ÷ 27 = cubic yards
  • Cubic meters × 1,000 = liters
  • Volume ÷ bag size = number of bags (always round up)

Example: three 4 × 8 ft beds

Three beds, each 8 ft × 4 ft inside, filled 10 inches deep, with a 10% allowance for settling, in 2 cu ft bags.

  1. One bed: 8 × 4 × (10 ÷ 12) = 26.67 ft³.
  2. Three beds: 80 ft³ = 2.963 yd³.
  3. Plus 10%: 88 ft³ (3.259 yd³).
  4. Bags: 88 ÷ 2 = 44 → 44 bags. In bulk: 3.5 yd³.

Metric example: one 2.4 × 1.2 m bed

  1. Volume = 2.4 × 1.2 × 0.30 = 0.864 m³ (864 liters).
  2. Plus 10%: 0.95 m³ = 950 liters.
  3. In 50 L bags: 20 bags. In bulk, round up to 1 m³.

What goes in a raised bed?

Raised beds are commonly filled with a blend of screened topsoil and compost, or a ready-made raised-bed mix. Blends with plenty of organic matter are lighter and drain more freely than mineral topsoil alone — which also means a 50 lb bag of one product can contain a very different volume from a 50 lb bag of another. Buy by volume where you can, and if the bag only states a weight, use the density setting in the calculator.

If you are mixing your own, calculate the total volume first, then split it by proportion. For a 70/30 topsoil–compost mix of 88 ft³, that is 61.6 ft³ of topsoil and 26.4 ft³ of compost.

Settling and topping up

Freshly filled beds sink as the soil settles and organic matter breaks down. The amount varies with the mix and with watering, so there is no universal figure. Two sensible approaches: add a modest allowance (the calculator starts at 10%, which you can change), or fill to your target height and plan to top up with compost at the start of the next season.

Very deep beds

Tall beds — 24 inches or more — need a lot of material. Some gardeners fill the lowest part with coarse organic material to reduce the amount of bought soil; if you do this, calculate soil only for the depth you will fill with it, and expect more settling as the lower layer decomposes.

Finishing the beds with a mulch layer? The Mulch Calculator works out bags for the top layer.

Use the Topsoil Calculator (choose “Raised bed(s)”) for identical beds, or the Garden Material Planner for beds of different sizes.

Sources

  1. NIST Special Publication 811 — Guide for the Use of the International System of Units (SI)

Sources were checked when this guide was published. Where published guidance differs, this guide says so; for structural work, follow your local specification.

Worked examples are generated by the same tested calculation engine as our calculators. See our editorial policy and methodology.